Input Patching - Barco ScreenPRO-II User Manual

5. System Setup

Input Patching

fåéìí=m~íÅÜáåÖ
ScreenPRO-II Controller system setup: Step 10
10
In this procedure, you will associate (patch) specific router inputs to specific source buttons
on the ScreenPRO-II Controller, and assign tally connections as desired.
The ScreenPRO-II Controller creates a unique " Input Patch Table " for each default router.
After a factory reset, the table defaults to the following settings:
Table 5-2. Default input patch table after factory reset
Router Router
Number Name
1 MatrixPRO1
2 MatrixPRO2
You may elect to use the "automatic" patches as shown above, or you can create custom
patches as required for specific input configurations.
Use the following steps to patch router inputs:
1.
2.
3.
4.
5.
198
Prerequisites — Ensure that you are familiar with the Input Source Patch
Menu . In Chapter 4, refer to the "
page 125.
Important You may not need to change the input patches if you want to
use those already contained in the default Input Patch Table .
Router Router
Type Input Sources:
Analog 1 - 16
SDI Undefined
Tip The same router input can be patched to one (or more)
source numbers. For example, if you want to use a DVD
player in both 16:9 and 4:3 formats, patch it to inputs 8 and 16
(the shifted source 8). Using the input setup procedure, set
up each input for the desired aspect ratio.
From the Home Menu , press SYSTEM to display the System Menu .
Press { INPUT PATCH } to display the Input Source Patch Menu .
On the Source Number line, select the source button on the Controller that you
want to patch.
On the Connection Type line, select the method by which the source is
connected:
~
Select a router by name (e.g., MatrixPRO ), or ...
~
Select an individual ScreenPRO-II ID , or ...
~
Select " ALL SP " to assume connections from D/As to similar inputs on
all ScreenPRO-IIs in your configuration.
If you selected a router, on the Router Input line, select the physical router input
that you wish to associate with the Controller's source number.
Input Source Patch Menu
Map to Controller
Sources:
1 - 16 1 - 8 defined only
Undefined Undefined
ScreenPRO-II Controller • User's Guide
" section on
Tally