Barco ScreenPRO-II User Manual page 210

5. System Setup
Input Setup
18. Press { SAVE } to save the input configuration.
19. Move the PIP into the next screen's region.
20. Repeat steps 13 through 19 for all remaining widescreen destinations.
21. When complete, clear the layer and transition it off program.
22. On the ScreenPRO-II Controller console, select LAYER B .
23. Repeat the entire procedure from step 6 — for the same source.
24. When you have completed setting up the first source for both layers, repeat the
`çäçê=_~ä~åÅÉ=^ÇàìëíãÉåíë
The following steps are a continuation of the complete widescreen source setup procedure.
Use the following steps to set up color balance for widescreen destinations — for all
types of analog sources — RGB , YUV , Composite and S-Video .
25. (
26. On the ScreenPRO-II Controller console, select LAYER A .
27. On the Source Selection Bus , select the first source that you want to set up.
28. Press PIP to display the PIP Adjustment Menu .
29. Scale the source such that it spans all screens in your widescreen configuration.
30. Press AUTO TRANS to transition the PIP to program. This will ensure that you
31. Press HOME > INPUT to display the Input Menu for the source.
32. Visually, find the pair of adjacent destinations that most closely match each other
33. On the Destination line, select the first "adjustment" destination.
34. Adjust the source as follows:
35. On the Destination line, select the next adjacent destination and repeat step 34
36. Repeat step 35 for all remaining destinations.
37. When complete, clear the layer and transition it off program.
38. On the ScreenPRO-II Controller console, select LAYER B .
39. Repeat the entire procedure from step 27 — for the same source.
40. When you have completed adjusting color balance for the first source for both
210
entire procedure from step 5 — for all remaining RGB and YUV sources that you
want to set up. Ensure that you set up both layers for each source.
Recommended ) Output a Gray Steps test pattern from the selected source.
can make your adjustments with data doubling and edge feathering visible.
across your widescreen blend regions. Select one of these as your "reference"
destination and the other as your first "adjustment" destination.
a. On the Input Menu , adjust Brightness and Contrast to visually match
the "reference" destination.
b. On the Color Balance Menu , adjust Red , Green , and Blue values to
visually match the "reference" destination. If a Composite or S-Video
source was selected, adjust Saturation and Hue .
c. Press { SAVE } to save the input configuration.
— matching Brightness , Contrast and Color Balance across the blend region.
layers, repeat the entire procedure from step 26 — for all remaining RGB , YUV ,
Composite and S-Video sources that you want to set up. Ensure that you set up
both layers for each source.
ScreenPRO-II Controller • User's Guide