Output Format Setup - Barco ScreenPRO-II User Manual

6.
7.
8.
9.
10. (Optional) If required, press
11. Press
12. Press
13. Press
lìíéìí=cçêã~í=pÉíìé
ScreenPRO-II Controller system setup: Step 11
11
In this procedure, you will configure the output format for each ScreenPRO-II that is used in
your ScreenPRO-II Controller system.
Use the following steps to set up the ScreenPRO-II output format:
1.
2.
3.
4.
5.
6.
7.
ScreenPRO-II Controller • User's Guide
If you selected an individual ScreenPRO-II ID or ALL SP , on the ScreenPRO-II
Input line, select the specific input connector on the ScreenPRO-II.
On the Tally Number line, select the tally that you want to associate with the
source button.
Press { ADD PATCH } to confirm your changes.
Repeat the procedure from step 3 to patch additional Controller buttons.
Controller input. This enables you to start again with an "undefined" patch.
{ }
BACK to return to the System Menu .
{ }
HOME to return to the Home Menu .
{ }
SAVE to save the new system configuration in memory.
Important If you elect to use tallies, the optional Tally board must be
installed, and relay connections must be run to the devices
that you wish to tally. In Appendix A, refer to the "
Connector
Prerequisites — Ensure that you are familiar with the Output Menu . In
Chapter 4, refer to the "
Important Be sure to select your projector's native resolution and a
frame rate that is consistent with your inputs — for example, if
you are using 59.94 NTSC video inputs, run the output at the
same rate in order to be synchronous.
From the Home Menu , press OUTPUT to display the Output Menu .
On the Destination Bus , select the destination that you want to configure.
On the Format line, select the resolution and frame rate at which you want to
drive the destination's projector(s). To minimize synchronization problems, select
a frame rate that is consistent with your input sources.
{ }
Press APPLY FORMAT
Repeat from step 2 to set additional destination output formats.
{ }
Press HOME to return to the Home Menu .
{ }
Press SAVE to save the new system configuration in memory.
{ }
DELETE PATCH to clear all registers for a selected
" section on page 262 for connector pinouts.
Output Menu Functions
to accept the selection.
5. System Setup

Output Format Setup

Tally
" section on page 102.
199