Barco ScreenPRO-II User Manual page 189

oÉíìêå=íç=c~Åíçêó=aÉÑ~ìäí
ScreenPRO-II Controller system setup: Step 3 .
In this procedure, you will perform a factory reset — in order to reset all router tables and
3
source mappings. The procedure guarantees that any previous setups and presets (e.g.,
those that may have been programmed by other users), do not remain in system memory.
Use the following steps to return the system to factory default values:
1.
2.
3.
4.
5.
qçìÅÜ=pÅêÉÉå=`~äáÄê~íáçå
ScreenPRO-II Controller system setup: Step 4 .
In this procedure, you will calibrate the Touch Screen.
4
Use the following steps to calibrate the Touch Screen:
1.
2.
3.
4.
ScreenPRO-II Controller • User's Guide
Prerequisite — Ensure that you are familiar with the System Reset Menu .
In Chapter 4, refer to the "
On the Home Menu , press SYSTEM to access the System Menu .
{ }
Press RESET to display the System Reset Menu .
On the Device line and select ALL .
Scroll to the Reset Type line and select FACTORY .
{ }
Press RESET . When the confirmation screen appears, press
user configurations and reset the system to factory default values.
Prerequisite — Ensure that you are familiar with the LCD Settings Menu . In
Chapter 4, refer to the "
On the Home Menu , press MISC to access the Miscellaneous Menu .
Press { LCD SETTINGS } to show the LCD Settings Menu .
Press { LCD Cal } to display the first Touch Screen Calibration Menu .
Follow the directions on the menu to complete the calibration procedure.
System Reset Menu " section on page 111.
LCD Settings Menu " section on page 139.
5. System Setup
Return to Factory Default
{ }
YES to delete all
189