Dsk Setup Procedure - Barco ScreenPRO-II User Manual

aph=pÉíìé=mêçÅÉÇìêÉ
ScreenPRO-II Controller system setup: Step 17
17
In this procedure, you will set up the system's DSK. Remember that the DSK can be
configured as a live DVI input or as a frame grab.
Use the following steps to set up your DSK source:
1.
2.
3.
4.
5.
6.
7.
ScreenPRO-II Controller • User's Guide
Prerequisites — Ensure that you are familiar with the following menus:
~
DSK Adjustment Menu . In Chapter 4, refer to the "
Menu " section on page 178.
~
DSK Input Setup Menu . In Chapter 4, refer to the "
Menu " section on page 180.
Note In both single and widescreen modes, remember that BG B
and the DSK are mutually exclusive. This occurs because
the BG/DSK Input B is shared between the DSK and BG B
on all individual ScreenPRO-II units.
Determine how you would like to configure your background and DSK sources.
As a recommendation, the following configuration is typically used:
~
The BG A input is configured as a live DVI source.
~
The BG/DSK Input B is used primarily as the DSK source, and
secondarily as a background frame grab source.
On the Destination Bus , select the destination whose DSK source you want to
configure.
On the ScreenPRO-II Controller console, press DSK to display the DSK
Adjustment Menu .
Press { INPUT SETUP } to display the DSK Input Setup Menu .
To configure a live DVI input as the DSK:
a. Ensure that your DVI source (PC) is properly connected to the
ScreenPRO-II chassis, and that the PC is turned on.
b. Ensure that EDID is properly set. If not, refer to the "
EDID " section on page 190 for details.
c. Scroll to the Type line and select DVI .
{
d. Press FORCE ACQUIRE
{ }
e. Press SAVE .
To configure a frame grab DSK:
a. Ensure that you have captured a still frame, either from a live DVI
background or from one of the two layers ( LAYER A or LAYER B ). In
Chapter 6, refer to the "
for instructions.
b. Scroll to the Type line and select FG_1 , FG_2 or FG_3 .
{ }
c. Press SAVE .
{ }
Press KEY to return to the DSK Adjustment Menu .
5. System Setup
}
.
Working with Still Frames

DSK Setup Procedure

DSK Adjustment
DSK Input Setup
Programming
" section on page 246
211