Router Setup - Barco ScreenPRO-II User Manual

oçìíÉê=pÉíìé
ScreenPRO-II Controller system setup: Step 8
In this procedure, you will set up the system's routing switchers.
8
Use the following steps to set up your system's routers:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. On the Number of Outputs line, select the routers' output count.
11. On the Communication Type line, select the type of communication that you are
12. Press
13. For Ethernet controlled routers, verify that the IP Address field matches the
14. Test communications:
ScreenPRO-II Controller • User's Guide
Prerequisites — Ensure that you are familiar with the following menus:
~
Router Specification Menu . In Chapter 4, refer to the "
Specification Menu
~
Comm Setup Menu . In Chapter 4, refer to the "
section on page 129.
~
Output Patch Menu . In Chapter 4, refer to the "
section on page 132.
Ensure that your router(s) are properly connected to the ScreenPRO-II Controller
system. In Chapter 3, refer to the "
For Ethernet controlled routers, ensure that your router's protocol is supported.
The list of supported manufacturers currently includes the Folsom MatrixPro
series, and routers from Sierra, Extron, Leitch, Isis, DVILink and DPI.
For Ethernet controlled routers, ensure that you know each router's IP address. If
required, preset IP addresses at the routers themselves. Refer to each router's
User's Guide for instructions.
Please note that MatrixPRO routers default to the following IP addresses:
~
MatrixPRO Analog Router: 192.168.0.241
~
MatrixPRO SDI Router: 192.168.0.242
From the Home Menu , press SYSTEM to access the System Menu .
{ }
Press

ROUTER SETUP

On the Number line, select the number of the router that you wish to configure.
On the Manufacturer line, select the router manufacturer.
On the Router Type line, select the type of router being used.
On the Number of Inputs line, select the router's input count.
using to connect to the router.
{ }
COMM SETUP to display the appropriate Comm Setup Menu for the
selected device.
router's IP address. If not, use the ADJ knob in conjunction with the
}
QUAD button to change the address as required.
~
For serial and Ethernet controlled routers, press { TEST COMM }.
~
For Lantronix devices, press
If the message " Communication Failed " appears, take the necessary actions to
rectify the error and repeat this step as required.
" section on page 127.
System Installation
to display the Router Specification Menu .
{
DISCOVER LTRX
5. System Setup
Router Setup
Router
Comm Setup Menus "
Output Patch Menu "
" section on page 73.
{
NEXT IP
}.
193