Barco ScreenPRO-II User Manual page 41

2. Hardware Orientation
Examples of destinations are listed below:
•
•
•
•
•
In Chapter 5, refer to the "
all destination setup procedures.
Following are descriptions of each button's function.
Destination/Aux Buttons — press to toggle the numbered destination on or off. Any
combination of destinations can be selected. The transitions that you perform will affect
1
only the selected destination(s). Please note:
•
•
•
•
DEST/AUX — press to switch the bus between standard (projector) destinations and Aux
(auxiliary) destinations, such as monitors.
DEST
•
AUX
•
ScreenPRO-II Controller • User's Guide
Single Screen Destination — this is a "single projector" destination that takes its
input from a ScreenPRO-II.
Wide Screen Destination — this is a "multiple projector" destination that takes its
inputs from two, three or four ScreenPRO-IIs, as routed through a BlendPRO-II.
Aux Destination — this is a single monitor that takes its input from one router
output (in a single format). When you select an Aux destination and a source on
the Controller, you are talking directly to a specific router output via RS-232 or
Ethernet communications — and making a source-to-destination connection.
ImagePRO Aux Destination — this is a standalone ImagePRO that takes its
input(s) from multiple routers, in multiple formats. When connected to a single
monitor or projector, a scaled output signal is provided — in one format. Whereas
an Aux Destination requires a single input format, an ImagePRO Aux Destination
accepts inputs in multiple formats.
PresentationPRO-II Aux Destination — similar to an ImagePRO Aux
destination, this is a standalone PresentationPRO-II that takes its input(s) from
standalone sources or routers, in multiple formats. When connected to a single
monitor or projector, a scaled signal is provided in one format.
Standard Destination Setup
The four destination buttons work in conjunction with the DEST/AUX button. See
the description of the DEST/AUX button (immediately below) for details.
Press a numbered destination button by itself to enable that destination and
toggle all other destinations off. In this mode, the buttons are mutually exclusive.
Press two or more destination buttons simultaneously to enable a "group" of
destinations. In this mode, the selected group is mutually exclusive with any other
active destinations:
Destinations 1 , 2 and 3 are lit. If you press destinations 1 and 2
simultaneously (to enable them), destination 3 turns off.
Use the All button to turn all destinations on or off. See the description of the All
button (below) for details.
When DEST/AUX is off, you are selecting standard (projector) destinations.
When DEST/AUX is lit, you are selecting Aux (auxiliary) destinations.
Front Panel Sections
" section on page 192 for details on
41