Aux Destination Setup - Barco ScreenPRO-II User Manual

5. System Setup

AUX Destination Setup

^ìñ=aÉëíáå~íáçå=pÉíìé
This section provides instructions for setting up an Aux destination.
Use the following steps to set up an Aux destination:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Press
11. Repeat from step 4 to configure additional Aux outputs.
12. Press
13. Press
14. Press
This completes the procedure for defining Aux destinations. The selected button(s) on the
Destination Bus are now active.
fã~ÖÉmol=çê=mêÉmolJff=^ìñ=aÉëíáå~íáçå=pÉíìé
This section provides instructions for setting up an ImagePRO Aux or PrePRO-II Aux
destination.
Use the following steps to set up an ImagePRO or PrePRO-II Aux destination:
1.
2.
3.
4.
5.
6.
196
Ensure that your have properly configured one (or more) router outputs as "Aux"
outputs. If not, refer to the "
From the Home Menu , press SYSTEM to access the System Menu .
{ }
Press DEST SETUP to display the Destination Setup Menu .
On the Destination line, select the Aux destination that you want to define —
either Aux 1 , Aux 2 , Aux 3 or Aux 4 .
Scroll to the Type line and select Aux .
Press { AUX SETUP } to display the Aux Setup Menu .
On the Source Mapping line, two choices are available:
~
Select Input Patch if you want to map Aux sources according to how
inputs are patched to buttons on the Source Selection bus. Note that
this is the typical choice.
~
Select Direct Map if you want the Source Selection bus to be a 1:1
mapping of your router inputs — for this Aux destination only.
On the Router Name line, select the router on which you configured the Aux
output(s).
On the Router Output line, select the specific router output that you wish to
designate as the Aux destination. Note that only outputs configured as " Aux " will
appear in the list.
{ }
BACK to return to the Destination Setup Menu .
{ }
BACK to return to the System Menu .
{ }
HOME to return to the Home Menu .
{ }
SAVE to save the new system configuration in memory.
Ensure that your have properly configured one (or more) router outputs as "Aux"
outputs. If not, refer to the "
From the Home Menu , press SYSTEM to access the System Menu .
{ }
Press DEST SETUP to display the Destination Setup Menu .
On the Destination line, select the Aux destination that you want to define —
either Aux 1 , Aux 2 , Aux 3 or Aux 4 .
Scroll to the Type line and select ImagePRO Aux or PrePRO-II Aux .
Press { AUX SETUP } to display the Aux Setup Menu .
Router Setup " section on page 193 for instructions.
Router Setup " section on page 193 for instructions.
ScreenPRO-II Controller • User's Guide