Comm Setup Menus; Output Patch Menu - Barco ScreenPRO-II User Manual

4. Menu Orientation
System Menu
•
•
•
•
•
oçìíÉê=fåíÉêÑ~ÅÉ=kçíÉë
For selected third party routers, additional interface information is provided below.
•
•
•
128
Communication Type — sets the device's communication type, either RS-232 ,
ETHERNET or LANTRONIX .
{ }
Press COMM SETUP to display one of three Comm Setup Menus , depending
on the selected Communication Type . Refer to the "
section on page 129 for details.
{
Press DELETE ROUTER
selected router Number to <EMPTY> .
{ }
Press ADD NEW after choosing an empty configuration's Manufacturer , Type ,
Number of Inputs and Number of Outputs to save a new router specification.
{ }
Press OUTPUT PATCH
"

Output Patch Menu

" section on page 132 for details.
Extron Router Support
The ScreenPRO-II Controller supports Extron routers enabled with Ethernet.
~
In the Router Specification Menu , set the Communication Type to
ETHERNET .
~
In the Ethernet Setup Menu , dial in the router's IP address, and keep
the port number set to 23 .
~
Press { TEST COMM } to establish communications.
Due to the Extron protocol, the router's matrix size will not be read by the
Controller, but will instead default to 16 x 16. When you return from the Ethernet
Setup Menu to the Router Specification Menu , dial in the proper number of
inputs and outputs to gain full access to the router.
Note Ensure that you set the router's IP address to work with the
ScreenPRO-II Controller's 192.168.0.xxx standard (e.g.,
192.168.0.245 ). Any 192.168.0.xxx address will work
provided it does not conflict with the Controller, VPs or other
network routers and devices.
DVILink 18x18 Router Support
The ScreenPRO-II Controller supports the DVILink 18x18 router enabled with
serial control. Connect the router to the EXT COMM port on the back of the
Controller. In Appendix A, refer to the "
for pinouts.
Sierra Video Systems Router Support
The ScreenPRO-II Controller supports Sierra Video Systems routers enabled with
serial control. Connect the router to the EXT COMM port on the back of the
Controller. In Appendix A, refer to the "
for pinouts.
}
to delete the current specification and change the
to display the Output Patch Menu . Refer to the
Serial Connector
Serial Connector
ScreenPRO-II Controller • User's Guide

Comm Setup Menus

"
" section on page 261
" section on page 261