Color Balance Adjustments - Barco ScreenPRO-II User Manual
Hide thumbs
Also See for ScreenPRO-II:
- Brochure (4 pages) ,
- Brochure & specs (6 pages) ,
- User manual (206 pages)
Table of Contents
Advertisement
8.
9.
10. Perform additional setups on the Color Balance Menu — if required :
ScreenPRO-II Controller • User's Guide
e.
Scroll to the Gamma line and set the input gamma.
f.
Scroll to the Input Sync Type line and set the type of sync used by the
selected source.
g.
Scroll to the Pulldown Compensation line and enable (or disable) the
mode.
h.
Scroll to the Sync Slice <mv> line and adjust as required.
i.
Scroll to the Sharpness line and set the input's sharpness.
{
}
j.
Press
SAVE
to save the input configuration.
Perform additional setups on the Aspect Ratio Menu — if required :
{
}
a.
Press
AR
to display the Aspect Ration Menu .
b.
Adjust the Mode and Ratio as required.
{
}
c.
Press
SAVE
to save the input configuration.
{
}
d.
Press
BACK
to return to the Input Menu .
Perform additional setups on the Sizing Menu — if required :
{
}
a.
Press
SIZING
to display the Sizing Menu .
b.
If 1:1 Sampling was selected:
•
Scroll to the Clock Phase line and set the system's A/D
converter.
•
Scroll to the H Total line and set the total pixel count per line.
•
Scroll to the H Active line and set the width of the active area.
•
Scroll to the H Position line and set the start of the active
area's horizontal offset from H sync.
•
Scroll to the V Active line and set the number of vertical lines in
the image.
•
Scroll to the V Position line and set the start of the active area's
vertical offset from V sync.
{
•
Press
SAVE
{
•
Press
BACK
c.
If Oversample was selected:
•
Scroll to the Right Edge line and adjust as required.
•
Scroll to the Left Edge line and adjust as required.
•
Scroll to the Top Edge line and adjust as required.
•
Scroll to the Bottom Edge line and adjust as required.
•
Press { SAVE } to save the input configuration.
•
Press { BACK } to return to the Input Menu .
{
a.
Press
COLOR BALANCE
b.
If an RGB source was selected:
•
Scroll to the Red Contrast line and adjust as required.
•
Scroll to the Red Brightness line and adjust as required.
•
Scroll to the Green Contrast line and adjust as required.
•
Scroll to the Green Brightness line and adjust as required.
•
Scroll to the Blue Contrast line and adjust as required.
•
Scroll to the Blue Brightness line and adjust as required.
•
Press { SAVE } to save the input configuration.
}
to save the input configuration.
}
to return to the Input Menu .
}
to display the Color Balance Menu .
5. System Setup
Input Setup
207
Advertisement
Table of Contents
