Logo Setup Procedure - Barco ScreenPRO-II User Manual

5. System Setup

LOGO Setup Procedure

8.
9.
10. When your DSK is fully adjusted, press
11. Press
ildl=pÉíìé=mêçÅÉÇìêÉ
ScreenPRO-II Controller system setup: Step 18
18
In this procedures, you will set up the system's LOGO. Remember that the LOGO can be
configured as black or as a frame grab.
Use the following steps to set up the LOGO:
1.
2.
3.
4.
212
On the Key Type line, select the type of key desired ( Luma or Color ).
Adjust key parameters as required:
~
For a Luma Key , adjust Invert Mode , Clip , Gain , Opacity and Fill
Source for the optimum visual key.
~
For a color key, pick the desired color, then adjust Red , Green and Blue
Color , Threshold , Mask and Opacity .
{ }
SAVE to save the new system configuration in memory.
Prerequisites — Ensure that you are familiar with the LOGO Menu . In
Chapter 4, refer to the "
On the Destination Bus , select the destination whose LOGO you want to
configure.
On the ScreenPRO-II Controller console, press LOGO to display the LOGO
Menu .
To configure a black LOGO:
a. Scroll to the Type line and select Black .
To configure a frame grab LOGO:
a. Ensure that you have captured a still frame, either from a live DVI
background or from one of the two layers ( LAYER A or LAYER B ). In
Chapter 6, refer to the "
for instructions.
b. Scroll to the Type line and select FG_1 , FG_2 or FG_3 .
{ }
HOME to return to the Home Menu .
LOGO Menu " section on page 182.
Working with Still Frames
ScreenPRO-II Controller • User's Guide
" section on page 246