Barco ScreenPRO-II User Manual page 242

6. Operations
Working with Transitions
3.
4.
j~åì~ä=qê~åëáíáçåë
Any of the transitions outlined above can be performed manually with the T-Bar .
Use the following steps to perform a manual transition:
1.
2.
3.
qê~åëáíáçå=kçíÉë
Using the Effects Menu , transitions performed on the ScreenPRO-II Controller are
destination-based. Two examples are provided below.
242
d. Adjust the Transition Edge field for the desired wipe edge.
Note
Key Frame effects are fixed as LINEAR , and cannot be
changed.
In the Transition Section , press WIPE .
Press AUTO TRANS to wipe the setup to Program.
Set up the desired "look" in Preview.
Select WIPE or MIX as desired. Remember that wipes can only be performed on
single screen destinations
In the Transition Section , move the T-Bar to manually dissolve (or wipe) the
images on Preview to Program.
Select destinations 1 and 3, then press WIPE . Next, select destination 2 only
and press MIX . Finally, select all three destinations and press AUTO TRANS
to simultaneously perform a wipe on destinations 1 and 3, and a dissolve on
destination 2.
Note In the above example, both the WIPE and MIX buttons would
be lit when all three destinations are selected.
If destinations 1, 2 and 3 are lit, and both the WIPE and MIX buttons are lit,
pressing MIX changes all three destinations to MIX .
ScreenPRO-II Controller • User's Guide