Barco ScreenPRO-II User Manual page 229

6. Operations
tçêâáåÖ=ïáíÜ=mfmë=áå=péäáí=jçÇÉ
In Split Mode , the mixer's two layers operate independently .
Use the following steps to work with PIPs in Split Mode .
1.
2.
Layer
A
3.
4.
5.
6.
7.
8.
tçêâáåÖ=ïáíÜ=mfmë=áå=jáñ=jçÇÉ
In Mix Mode , the mixer's layers are ganged together. Both PIPs can be perfectly co-
located on screen ( Mix Source mode), or both can operate independently ( Swap mode),
but only one PIP can be on Program at a time.
Use the following steps to work with PIPs in Mix Mode .
1.
2.
ScreenPRO-II Controller • User's Guide
Note Even though this mode allows you to display two PIPs (or
Keys) on air, it is more restrictive. Once both layers are on
Program, you must transition them off Program, make
changes — and then transition them back on.
In the Layer Control Section , ensure that the Split button is On .
Press the desired layer button ( A or B ). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the Source Selection Bus , the source assigned to the layer blinks.
~
On Preview, the raster box for the selected layer blinks (even if it is
hidden under another layer).
In the Layer Functions Section , ensure that the PIP button is lit and the PIP
Adjustment Menu is visible. If the menu is not visible, press PIP .
Note Even if the layer is on Program, the PIP Adjustment Menu
appears, but parameters can not be adjusted.
On the Source Selection Bus , press the button for the desired (new) source.
The button blinks to indicate that it is selected, and the source appears within the
PIP on Preview.
Adjust the PIP's size, position, border, shadow, source image, cropping and
special effects. Refer to the "
Prior to the transition, you can set up an additional layer if desired in Split Mode :
~
To set up an additional " Split Mode " PIP in Preview, repeat the
procedure from step 2.
~
To set up a Key in Preview, refer to the "
Mode " section on page 231.
Press CUT or AUTO TRANS to transition the look to program. Refer to the
" Working with Transitions
Repeat the procedure from step 1 for the next transition.
In the Layer Control Section , ensure that the Split button is Off .
Press the desired layer button ( A or B ). Please note:
~
The layer button blinks to indicate that it is active for modification.
~
In the Source Selection Bus , the source assigned to the layer blinks.
Modifying PIPs " section on page 230 for details.
Working with Keys in Split
" section on page 241 for details.
Working with Layers
229