Barco ScreenPRO-II User Manual page 97

lîÉêë~ãéäÉ=páòáåÖ=jÉåì
The figure below illustrates the Oversample Sizing Menu . All functions apply to the
selected source.
B
A
C
K
S
A
V
E
Figure 4-7. Oversample Sizing Menu (sample)
With Oversample enabled, the following timing parameters allow you to adjust the image
to properly fit the layer's blinking raster box.
•
•
•
•
ScreenPRO-II Controller • User's Guide
OVERSAMPLE SIZING
ID
Layer
Right Edge
Left Edge
Top Edge
Bottom Edge
ID — indicates the ID of the associated ScreenPRO-II.
Note The ID line only appears when a widescreen destination is
selected.
~
If " All " is shown in a widescreen configuration, menu values represent
those of the lowest numbered ID in the destination. When a parameter is
adjusted, all values for all ScreenPRO-II's in the destination will snap to
the new value.
~
If an individual ID is shown (e.g., 2 ), it represents that ScreenPRO-II
alone, and adjustments will only affect that unit.
Layer — for widescreen destinations, indicates the layer on which you are
adjusting the selected input.
Important In a widescreen configuration, because the electronics on
individual ScreenPRO-II scalers may not match from unit to
unit, you may be required to adjust ScreenPRO-II scalers and
layers individually — by first selecting a specific destination
ID, followed by a specific layer.
Select and adjust Right Edge , Left Edge , Top Edge or Bottom Edge as
required, to fit the image precisely in the layer's blinking raster box.
{ }
Press SAVE to save the selected input in the designated input file.
4. Menu Orientation
Input Menu
SRC_1
ALL
N
A
[ A ]
V
1320
296
35
803
A
D
J
FORCE
ACQUIRE
97