Barco ScreenPRO-II User Manual page 144

4. Menu Orientation
Frame Grab Menu
system is powered down. Thus, at any one time, you could have a maximum of three stills
in temporary memory, and three different stills in permanent memory.
At bootup, the contents of flash memory is read into "temp" memory for use on-air. It takes
several minutes to save a still into permanent memory, and this procedure should not be
performed on-air. Permanent frames can also be overwritten.
The following Frame Grab Menu functions are provided:
•
•
•
•
•
•
•
•
•
•
•
•
In Chapter 6, refer to the "
144
Destination — displays the currently selected destination.
ID — displays the ID(s) of the selected destination's associated ScreenPRO-II
system(s).
Frame Number — enables you to select FG_1 , FG_2 or FG_3 for capture,
storage, erasure, recall or deletion.
Capture Format — displays the output resolution. Each ScreenPRO-II always
captures a full screen image at the output resolution — regardless of the input
resolution.
Name — displays the name of the file.
~
UNSAVED indicates that the file's source is temporary memory.
~
SAVED indicates that the file is permanently stored. If this appears, the
permanent file has been read into "temp" memory for use on-air.
Format — displays the resolution of the captured frame.
Press { NAME } to display the Frame Grab Name Menu . Refer to the "
Grab Name Menu " section on page 145 for details.
Press { ERASE } to permanently erase the selected frame from permanent (flash)
memory. This process takes from 1 to 2 minutes, and locks the console during the
procedure. You will be asked to confirm before proceeding.
Note You can perform this function even if there is no frame stored
in the permanent register.
Press { CAPTURE } to capture a still into the selected "temporary" frame store.
Once pressed, the screen will indicate that the frame is being captured.
Press { SAVE } to save the captured frame into permanent (flash) memory within
the selected register. This process takes from 2 to 3 minutes, and locks the
console during the procedure. You will be asked to confirm before proceeding.
Press { DELETE } to mark the selected permanent frame as deleted — but note
that the ERASE function is still required for permanent deletion. You can consider
this as a "quick" delete function.
Press { RECALL } to recall a selected frame from permanent (flash) storage back
into temporary memory.
Working with Still Frames " section on page 246 for instructions.
ScreenPRO-II Controller • User's Guide
Frame