Attaching The Walking Foot - Brother 882-D10 Operation Manual

CHANGING THE PRESSER FOOT

■ Attaching the Walking foot

The walking foot holds the fabric between the
presser foot and the feed dogs to feed the fabric. This
enables you to have better fabric control when
sewing difficult fabrics (such as quilted fabrics or
velvet) or fabrics that slip easily (such as vinyl,
leather, or synthetic leather).
a
Follow the steps in "Removing the Presser
Foot" in the previous page.
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
a Disc-shaped screwdriver
b Presser foot holder
c Presser foot holder screw
c
Remove the screw of the presser foot
completely from the presser foot shaft.
d
Set the adapter on the presser foot bar,
aligning the flat side of the adapter opening
with the flat side of the presser bar. Push it
up as far as possible, and then tighten the
screw securely with the screwdriver.
B-48
e
Turn a supplied small screw 2 or 3 times
with your hand.
f
Set the operation lever of the walking foot
so that the needle clamp screw is set
between the forks. Position the shank of the
walking foot on the adapter attached to the
presser foot bar.
a Operation lever
b Needle clamp screw
c Fork
d Walking foot shank
e Adapter
g
Lower the presser foot lever. Tighten the
small screw securely with a large
screwdriver.
Note
• Thread the needle manually when using the
walking foot, or only attach the walking foot
after threading the needle using the
"Automatic Threading" button.