Using The Automatic Thread Cutting Function (End Color Trim); Using The Thread Trimming Function (Jump Stitch Trim); Adjusting The Embroidery Speed - Brother NQ3600D Operation Manual

Making Embroidery Adjustments
Using the automatic thread cutting function
(END COLOR TRIM)
The automatic thread cutting function will cut the thread at
the end of sewing each color. This function is initially turned
on. To turn this function off, press
a
Press .
b
Press to turn off the automatic thread cutting
function.
 The key will display as
• When one color thread is sewn, the machine will
stop without cutting the thread.
c
Press to return to the original screen.
Using the Thread Trimming Function (JUMP
STITCH TRIM)
The thread trimming function
excess thread jumps within the color. Embroidery frame
(small) cannot be used. This function is initially turned on. To
turn this function off, press
* Your customized setting remains after turning the machine
off and on.
CAUTION
• The carriage of the embroidery unit will move.
Keep your hands etc. away from the carriage.
Otherwise injury may result.
E-28
key and then .
will automatically trim any
key and then .
1 Jump stitch
Note
• When this function is turned on, use the included
ball point needle 75/11 for embroidering patterns
with short jump stitches such as alphabet
characters. Using other needles may cause the
thread to break.
■ Selecting the Length of Jump Stitch Not to Trim
When the thread trimming function
can select the length of the jump stitch not to trim the
thread.
Select a setting from 5 mm to 50 mm in 5 mm increments.
* Your customized setting remains after turning the
machine off and on.
Press or to select the length of jump stitch.
For example: Press to select 25 mm (1 inch) and the
machine will not trim a jump stitch of 25 mm or less
before moving to the next stitching.
Note
• If design has many trims it is recommended to
select a higher jump stitch trim setting in order to
reduce the amount of excess tails on backside of
fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the machine
will trim. In this case, more jump stitches will
remain on the surface of the fabric.

Adjusting the embroidery speed

a
Press to display the following screen.
b
Change the "Max Embroidery Speed" by pressing
/ .
c
Press to return to the original screen.
is turned on, you