Configuring The Switch For The First Time; Default Configuration - Cisco WS-SUP32-GE-3B - Supervisor Engine 32 Software Configuration Manual

Configuring the Switch for the First Time

This chapter contains information about how to initially configure the Catalyst 6500 series switch, which
supplements the administration information and procedures in these publications:
•
•
For complete syntax and usage information for the commands used in this chapter, refer to these
Note
publications:
•
•
This chapter consists of these sections:
•
•
•
•
•

Default Configuration

Table 3-1
OL-11439-03
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/configfun/configuration/guide/ffun_c.html
Cisco IOS Configuration Fundamentals Configuration Command Reference, Release 12.2, at
this URL:
http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/ffun_r.html
The Catalyst Supervisor Engine 32 PISA Cisco IOS Command Reference, Release 12.2ZY, at
this URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2ZY/command/reference/cmdr
ef.html
The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
Default Configuration, page 3-1
Configuring the Switch, page 3-2
Protecting Access to Privileged EXEC Commands, page 3-14
Recovering a Lost Enable Password, page 3-18
Modifying the Supervisor Engine Startup Configuration, page 3-19
shows the default configuration.
Catalyst Supervisor Engine 32 PISA Cisco IOS Software Configuration Guide, Release 12.2ZY
3
C H A P T E R
3-1