Table of Contents
Advertisement
Media Flow Manager Administrator's Guide
connections are only accepted on those specified interfaces. When disabled, SSH
connections are accepted on any interface.
•
interface <interface_name>
the interface is also running as a DHCP client, it is as if the interface was not added. If
DHCP is later turned off on this interface, it is as if the interface was then added to the
listen list. Use no ssh server listen interface <interface_name> to delete entries.
•
min-version
Default is 2. Use no ssh server min-version to reset to default.
•
ports
specified by repeating the <port> entry. There must be at least one port specified on the
system for the SSH server. Removes any previous ports if not listed in the command.
show ssh server [host-keys]
SSH server information, including whether or not it is enabled, and the host key fingerprints.
Use the host-keys option to display information about the SSH server, including whether or
not it is enabled, the host key fingerprints, and the full host keys.
stats
Configure statistics and alarms. To see default threshold values, enter show stats alarm
<alarm_ID>. Set email notifications for these stats using
Log Statistics Thresholds" on page 100
stats
alarm <alarm_ID>
clear
enable
falling [clear-threshold <value>] [error-threshold <value>]
rate-limit
rising [clear-threshold <value>] [error-threshold <value>]
chd <CHD_ID>
clear
compute time [interval <seconds>] [range <seconds>]
clear-all
export {<format> | csv} {<report_name>| cpu_util | memory | paging}
after <date><time> [before <date><time>]
before <date><time> [after <date><time>]
filename <filename>
sample <sample_ID>
clear
interval <number_of_seconds>
—Set the minimum version of the SSH protocol that the server supports.
—Specify on which ports the SSH server listens; default is 22. Multiple ports can be
count {long <count> | medium <count> | short <count>}
reset
window {long<duration> | medium<duration> | short<duration>}
after <date><time> [before <date><time>]
before <date><time> [after <date><time>]
—Add interfaces to the listen list; default is eth0. If
email
for task details.
CHAPTER 5 CLI Commands
commands. See
"Configuring
stats
141
Advertisement
Table of Contents
