Ipv6 Ospf Cost; Ipv6 Ospf Dead-Interval - NETGEAR GSM7228PS Cli Manual

ipv6 ospf cost

This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1
to 65535.
Default 10
Format
ipv6 ospf cost <1-65535>
Mode Interface Config
no ipv6 ospf cost
This command configures the default cost on an OSPF interface.
Format
no ipv6 ospf cost
Mode Interface Config

ipv6 ospf dead-interval

This command sets the OSPF dead interval for the specified interface. The value for <seconds>
is a valid positive integer, which represents the length of time in seconds that a router's Hello
packets have not been seen before its neighbor routers declare that the router is down. The value
for the length of time must be the same for all routers attached to a common network. This value
should be some multiple of the Hello Interval (i.e., 4). Valid values range for <seconds> is from
1 to 2147483647.
Default 40
Format
ipv6 ospf dead-interval <seconds>
Mode Interface Config
no ipv6 ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format
no ipv6 ospf dead-interval
Mode Interface Config
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
7-34