Storm-Control Broadcast Rate - NETGEAR GSM7228PS Cli Manual

storm-control broadcast rate

Use this command to configure the broadcast storm recovery threshold for an interface in packets
per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
Default 0
Format
storm-control broadcast rate <0-14880000>
Mode Interface Config
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an interface and
disables broadcast storm recovery.
Format
no storm-control broadcast rate
Mode Interface Config
storm-control broadcast (Global Config)
This command enables broadcast storm recovery mode for all interfaces. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
broadcast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control broadcast
Mode Global Config
no storm-control broadcast
This command disables broadcast storm recovery mode for all interfaces.
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-80