Sflow Poller - NETGEAR GSM7228PS Cli Manual

Field Description
Sampling Rate The statistical sampling rate for packet sampling from this source. A sampling rate of 1
counts all packets. A value of zero (0) disables sampling. A value of N means that out of N
incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The default
is 0.
no sflow sampler
Use this command to reset the sFlow sampler instance to the default settings.
Format
no sflow sampler {<rcvr-indx> | rate <sampling-rate> | maxheadersize
<size>}
Mode Interface Config

sflow poller

A data source configured to collect counter samples is called a poller. Use this command to enable
a new sFlow poller instance for this data source if <rcvr_idx> is valid.
Format
sflow poller {<rcvr-indx> | interval <poll-interval>}
Mode Interface Config
Field Description
Receiver Index Enter the sFlow Receiver associated with the sampler/poller. A value of zero (0) means
that no receiver is configured. The range is 1-8. The default is 0.
Poll Interval Enter the sFlow instance polling interval. A poll interval of zero (0) disables counter
sampling. When set to zero (0), all the poller parameters are set to their corresponding
default value. The range is 0-86400. The default is 0. A value of N means once in N
seconds a counter sample is generated.
no sflow poller
Use this command to reset the sFlow poller instance to the default settings.
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-86