Routing Information Protocol (Rip) Commands; Show Ip Ospf Virtual-Link Brief; Router Rip; Enable (Rip) - NETGEAR GSM7228PS Cli Manual

show ip ospf virtual-link brief

This command displays the OSPF Virtual Interface information for all areas in the system.
Format
show ip ospf virtual-link brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID The area id of the requested OSPF area.
Neighbor The neighbor interface of the OSPF virtual interface.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Retransmit The configured retransmit interval for the OSPF virtual interface.
Interval
Transit Delay The configured transit delay for the OSPF virtual interface.

Routing Information Protocol (RIP) Commands

This section describes the commands you use to view and configure RIP, which is a distance-
vector routing protocol that you use to route traffic within a small network.

router rip

Use this command to enter Router RIP mode.
Format
router rip
Mode Global Config

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
Default enabled
Format
enable
Mode Router RIP Config
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-82