Show Interface - NETGEAR GSM7228PS Cli Manual

show interface

This command displays a summary of statistics for a specific interface or a count of all CPU traffic
based upon the argument.
Format
show interface {<unit/slot/port> | switchport}
Mode Privileged EXEC
The display parameters, when the argument is <unit/slot/port>, are as follows:
Parameters Definition
Packets The total number of packets (including broadcast packets and multicast packets) received
Received
by the processor.
Without Error
Packets The number of inbound packets that contained errors preventing them from being
Received With
deliverable to a higher-layer protocol.
Error
Broadcast The total number of packets received that were directed to the broadcast address. Note
Packets
that this does not include multicast packets.
Received
Packets The total number of packets transmitted out of the interface.
Transmitted
Without Error
Transmit The number of outbound packets that could not be transmitted because of errors.
Packets Errors
Collisions The best estimate of the total number of collisions on this Ethernet segment.
Frames
Time Since The elapsed time, in days, hours, minutes, and seconds since the statistics for this port
Counters Last
were last cleared.
Cleared
The display parameters, when the argument is "switchport" are as follows:
Term Definition
Packets The total number of packets (including broadcast packets and multicast packets) received
Received
by the processor.
Without Error
Broadcast The total number of packets received that were directed to the broadcast address. Note
Packets
that this does not include multicast packets.
Received
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-9