Show Ip Vrrp Interface - NETGEAR GSM7228PS Cli Manual

show ip vrrp interface

This command displays all configuration information and VRRP router statistics of a virtual router
configured on a specific interface. Use the output of the command to verify the track interface and
track IP route configurations.
Format
show ip vrrp interface {<unit/slot/port> <vrid> | vlan <1-4093>}
Modes • Privileged EXEC
• User EXEC
Term Definition
Primary IP The configured IP address for the Virtual router.
Address
VMAC address The VMAC address of the specified router.
Authentication The authentication type for the specific virtual router.
type
Priority The priority value for the specific virtual router, taking into account any priority decrements
for tracked interfaces or routes.
Configured The priority configured through the ip vrrp <vrid> priority <1-254> command.
Priority
Advertisement The advertisement interval in seconds for the specific virtual router.
interval
Pre-Empt Mode The preemption mode configured on the specified virtual router.
Administrative The status (Enable or Disable) of the specific router.
Mode
State The state (Master/backup) of the virtual router.
The following shows example CLI display output for the command.
show ip vrrp interface <u/s/p> <vrid>
Primary IP Address............................. 1.1.1.5
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 80
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Enable
State.......................................... Initialized
Track Interface
---------------
Routing Commands
State DecrementPriority
------ ------------------
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
4-33