Network Interface Commands; Enable (Privileged Exec Access); Network Parms - NETGEAR GSM7228PS Cli Manual

There are changes detected, do you wish to save the changes permanently
(Y/N)? y
The configuration changes have been saved succesfully. Please enter 'show
running-config' to see the final configuration.
Thanks for using EzConfig!

Network Interface Commands

This section describes the commands you use to configure a logical interface for management
access. To configure the management VLAN, see

enable (Privileged EXEC access)

This command gives you access to the Privileged EXEC mode. From the Privileged EXEC mode,
you can configure the network interface.
Format
enable
Mode User EXEC

network parms

This command sets the IP address, subnet mask and gateway of the device. The IP address and the
gateway must be on the same subnet.
Format
network parms <ipaddr> <netmask> [<gateway>]
Mode Privileged EXEC
Management Commands
Managed Switch CLI Manual, Release 8.0.3
"network mgmt_vlan" on page
v1.0, July 2010
3-31.
10-4