Snmp-Server Enable Traps Stpmode - NETGEAR GSM7228PS Cli Manual

no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode Global Config

snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification traps.
Default enabled
Format
snmp-server enable traps stpmode
Mode Global Config
no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
Format
no snmp-server enable traps stpmode
Mode Global Config
snmptrap
This command adds an SNMP trap receiver. The maximum length of <name> is 16 case-sensitive
alphanumeric characters. The <snmpversion> is the version of SNMP. The version parameter
options are snmpv1 or snmpv2. The SNMP trap address can be set using both an IPv4 address
format as well as an IPv6 global address format.
The following shows an example of the CLI command.
(Netgear Switch)# snmptrap mytrap ip6addr 3099::2
Management Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
10-46