NETGEAR GSM7228PS Cli Manual page 27

switch renumber
This command changes the switch identifier for a switch in the stack. The <oldunit> is the
current switch identifier on the switch whose identifier is to be changed. The <newunit> is the
updated value of the switch identifier. Upon execution, the switch will be configured with the
configuration information for the new switch, if any. The old switch configuration information will
be retained, however the old switch will be operationally unplugged. This command is executed on
the Primary Management Unit.
Note: If the management unit is renumbered, then the running configuration is no longer
applied (i.e. the stack acts as if the configuration had been cleared)
Format
switch <oldunit> renumber <newunit>
Mode Global Config
movemanagement
This command moves the Primary Management Unit functionality from one switch to another.
The <fromunit> is the switch identifier on the current Primary Management Unit. The
<tounit> is the switch identifier on the new Primary Management Unit. Upon execution, the
entire stack (including all interfaces in the stack) is unconfigured and reconfigured with the
configuration on the new Primary Management Unit. After the reload is complete, all stack
management capability must be performed on the new Primary Management Unit. To preserve the
current configuration across a stack move, execute the copy system:running-config
nvram:startup-config (in Privileged EXEC) command before performing the stack move.
A stack move causes all routes and layer 2 addresses to be lost. This command is executed on the
Primary Management Unit. The system prompts you to confirm the management move.
Format
movemanagement <fromunit> <tounit>
Mode Stack Global Config
Stacking Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
2-3