Snmp-Server Enable Traps Linkmode; Snmp-Server Enable Traps Multiusers - NETGEAR GSM7228PS Cli Manual

no snmp-server enable traps
This command disables the Authentication Flag.
Format
no snmp-server enable traps
Mode Global Config

snmp-server enable traps linkmode

Note: This command may not be available on all platforms.
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are
sent only if the Link Trap flag setting associated with the port is enabled. See
status" on page 10-48
Default enabled
Format
snmp-server enable traps linkmode
Mode Global Config
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode Global Config

snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing
terminal interface session.
Default enabled
Format
snmp-server enable traps multiusers
Mode Global Config
Management Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
"snmp trap link-
10-45