Show Captive-Portal Configuration Status - NETGEAR GSM7228PS Cli Manual

show captive-portal configuration status

Use this command to display information about all configured captive portal configurations or
about a specific captive portal configuration. The <1-10> is captive portal ID. If <1-10> is not
entered, all the configurations are displayed.
Format
show captive-portal configuration [ <1-10> ] status
Mode Privileged EXEC mode
Term Definition
CP ID The captive portal instance ID
CP Name The captive portal instance name
Mode The operational mode is enabled or disabled.
Protocol Mode The protocol mode is https or http.
Verification Mode The user verification mode has three modes: guest , local and radius. The default is
guest mode.
If the interface is specified, the following terms are displayed.
Term Definition
Group Name The name of the group associated with this captive portal instance.
Redirect URL Mode The redirect mode for this captive portal instance
Redirect URL The redirect URL is up to 512 characters.
Session Timeout Logout once session timeout is reached (seconds).
Idle Timeout Logout once idle timeout is reached (seconds).
Max Bandwidth Up Maximum client transmit rate (b/s). Limits the bandwidth at which the client can send
data into the network.
Max Bandwidth Maximum client receive rate (b/s). Limits the bandwidth at which the client can receive
Down
data from the network.
Max Input Octets Maximum number of octets the
user is allowed to transmit.After this limit has been reached the user will be
disconnected.
Max Output Octets Maximum number of octets the user is allowed to receive. After this limit has been
reached the user will be disconnected.
Max Total Octets Maximum number of octets the user is allowed to transfer (sumof octets transmitted and
received). After this limit has been reached the user will be disconnected.
Captive Portal Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
12-17