Set Igmp Querier - NETGEAR GSM7228PS Cli Manual

This section describes commands used to configure and display information on IGMP Snooping
Queriers on the network and, separately, on VLANs.

set igmp querier

Use this command to enable IGMP Snooping Querier on the system, using Global Config mode, or
on a VLAN. Using this command, you can specify the IP Address that the Snooping Querier
switch should use as the source address while generating periodic queries.
If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled on
it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping functionality
is re-enabled if IGMP Snooping is operational on the VLAN.
Note: The Querier IP Address assigned for a VLAN takes preference over global
configuration.
The IGMP Snooping Querier application supports sending periodic general queries on the VLAN
to solicit membership reports.
Default disabled
Format
set igmp querier [<vlan-id>] [address ipv4_address]
Mode • Global Config
• VLAN Mode
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional address
parameter to reset the querier address to 0.0.0.0.
Format
no set igmp querier [<vlan-id>] [address]
Mode • Global Config
• VLAN Mode
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-149