Show Igmpsnooping - NETGEAR GSM7228PS Cli Manual

show igmpsnooping

This command displays IGMP Snooping information. Configured information is displayed
whether or not IGMP Snooping is enabled.
Format
show igmpsnooping [<unit/slot/port> | <vlan_id>]
Mode Privileged EXEC
When the optional arguments <unit/slot/port> or <vlan_id> are not used, the command
displays the following information:
Term Definition
Admin Mode Indicates whether or not IGMP Snooping is active on the switch.
Multicast The number of multicast control frames that are processed by the CPU.
Control Frame
Count
Interface The list of interfaces on which IGMP Snooping is enabled.
Enabled for
IGMP Snooping
VLANS Enabled The list of VLANS on which IGMP Snooping is enabled.
for IGMP
Snooping
When you specify the <unit/slot/port> values, the following information appears:
Term Definition
IGMP Snooping Indicates whether IGMP Snooping is active on the interface.
Admin Mode
Fast Leave Indicates whether IGMP Snooping Fast-leave is active on the interface.
Mode
Group The amount of time in seconds that a switch will wait for a report from a particular group
Membership
on a particular interface before deleting the interface from the entry.This value may be
Interval
configured.
Maximum The amount of time the switch waits after it sends a query on an interface because it did
Response Time
not receive a report for a particular group on that interface. This value may be configured.
Multicast The amount of time to wait before removing an interface from the list of interfaces with
Router Expiry
multicast routers attached. The interface is removed if a query is not received. This value
Time
may be configured.
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-146