Show Captive-Portal Configuration Locales - NETGEAR GSM7228PS Cli Manual

Example
(switch)#show captive-portal configuration status
CP ID CP Name
----- ----------
1 cp1
2 cp2
3 cp3
(switch)#show captive-portal configuration 1 status
CP ID.......................................... 1
CP Name........................................ cp1
Mode........................................... Enabled
Protocol Mode.................................. https
Verification Mode.............................. Guest
Group Name..................................... group123
Redirect URL Mode.............................. Enabled
Redirect URL................................... www.cnn.com
Session Timeout (seconds)...................... 86400
Idle Timeout (seconds)......................... 600
Max Bandwidth Up (bytes/sec)................... 0
Max Bandwidth Down (bytes/sec)................. 0
Max Input Octets (bytes)....................... 0
Max Output Octets (bytes)...................... 0
Max Total Octets (bytes)....................... 0

show captive-portal configuration locales

Use this command to display locales associated with a specific captive portal configuration. <1-
10> is captive port ID.
Format
show captive-portal configuration <1-10> locales
Mode Privileged EXEC mode
Example
(switch)#show captive-portal configuration 1 locales
Locale Code
---------------
En
Captive Portal Commands
Mode Protocol
-------- --------
Enable https
Enable http
Disable https
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
Verification
------------
Guest
Local
Guest
12-18