NETGEAR GSM7228PS Cli Manual page 459

enable (OSPFv3)
This command resets the default administrative mode of OSPF in the router (active).
Default enabled
Format
enable
Mode Router OSPFv3 Config
no enable (OSPFv3)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode Router OSPFv3 Config
exit-overflow-interval (OSPFv3)
This command configures the exit overflow interval for OSPF. It describes the number of seconds
after entering Overflow state that a router will wait before attempting to leave the overflow state.
This allows the router to again originate non-default AS-external-LSAs. When set to 0, the router
will not leave overflow state until restarted. The range for <seconds> is 0 to 2147483647
seconds.
Default 0
Format
exit-overflow-interval
Mode Router OSPFv3 Config
no exit-overflow-interval(OSPFv3)
This command configures the default exit overflow interval for OSPF.
Format
no exit-overflow-interval
Mode Router OSPFv3 Config
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
< >
seconds
v1.0, July 2010
7-49