NETGEAR GSM7228PS Cli Manual page 463

Group Flags
errors • authentication-failure
• bad-packet
• config-error
• virt-authentication-failure
• virt-bad-packet
• virt-config-error
if-rx ir-rx-packet
lsa • lsa-maxage
• lsa-originate
overflow • lsdb-overflow
• lsdb-approaching-overflow
retransmit • packets
• virt-packets
rtb • rtb-entry-info
state-change • if-state-change
• neighbor-state-change
• virtif-state-change
• virtneighbor-state-change
• To enable the individual flag, enter the group name followed by that particular flag.
• To enable all the flags in that group, give the group name followed by all.
• To enable all the flags, give the command as trapflags all.
IPv6 Commands
Table 2: Trapflag Groups (OSPFv3)
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
7-53