Lacp Partner Admin State Passive; Lacp Partner Port Id - NETGEAR GSM7228PS Cli Manual

lacp partner admin state passive

Use this command to set the LACP partner admin state to passive.
Format
lacp partner admin state passive
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
Format
no lacp partner admin state passive
Mode Interface Config

lacp partner port id

Use this command to configure the LACP partner port id. The valid range for <port-id> is 0 to
65535.
Default 0x80
Format
lacp partner portid <port-id>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-100