NETGEAR GSM7228PS Cli Manual page 557

logging console
This command enables logging to the console. You can specify the <severitylevel> value as
either an integer from 0 to 7 or symbolically through one of the following keywords: emergency
(0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug
(7).
Default disabled; critical when enabled
Format
logging console [severitylevel]
Mode Global Config
no logging console
This command disables logging to the console.
Format
no logging console
Mode Global Config
logging host
This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname> is the IP address of the logging host. The <addresstype> indicates
the type of address ipv4 or ipv6 or dns being passed. The <port> value is a port number from 1
to 65535. You can specify the <severitylevel> value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7).
Default • port—514
• level—critical (2)
Format
logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode Global Config
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-20