NETGEAR GSM7228PS Cli Manual page 335

Format
ip rip send version {rip1 | rip1c | rip2 | none}
Mode Interface Config
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be
sent.
Format
no ip rip send version
Mode Interface Config
hostroutesaccept
This command enables the RIP hostroutesaccept mode.
Default enabled
Format
hostroutesaccept
Mode Router RIP Config
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
no hostroutesaccept
Mode Router RIP Config
split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for avoiding problems
caused by including routes in updates sent to the router from which the route was originally
learned. The options are: None - no special processing for this case. Simple - a route will not be
included in updates sent to the router from which it was learned. Poisoned reverse - a route will be
included in updates sent to the router from which it was learned, but the metric will be set to
infinity.
Default simple
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-87