Ip Dhcp Pool - NETGEAR GSM7228PS Cli Manual

ip dhcp pool

This command configures a DHCP address pool name on a DHCP server and enters DHCP pool
configuration mode.
Default none
Format
ip dhcp pool <name>
Mode Global Config
no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured pool
name.
Format
no ip dhcp pool <name>
Mode Global Config
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation of the
media type and the MAC address. For example, the Microsoft client identifier for Ethernet address
c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. For more
information, refer to the "Address Resolution Protocol Parameters" section of RFC 1700,
Assigned Numbers for a list of media type codes.
Default none
Format
client-identifier <uniqueidentifier>
Mode DHCP Pool Config
no client-identifier
This command deletes the client identifier.
Format
no client-identifier
Mode DHCP Pool Config
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-41