NETGEAR GSM7228PS Cli Manual page 562

traceroute
Use the traceroute command to discover the routes that packets actually take when traveling
to their destination through the network on a hop-by-hop basis. Traceroute continues to provide a
synchronous response when initiated from the CLI.
Default • count: 3 probes
• interval: 3 seconds
• size: 0 bytes
• port: 33434
• maxTtl: 30 hops
• maxFail: 5 probes
• initTtl: 1 hop
•
Format
traceroute <ipaddr|hostname> [initTtl <initTtl>] [maxTtl <maxTtl>]
[maxFail <maxFail>] [interval <interval>] [count <count>]
[port <port>] [size <size>]
Mode Privileged EXEC
Using the options described below, you can specify the initial and maximum time-to-live (TTL) in
probe packets, the maximum number of failures before termination, the number of probes sent for
each TTL, and the size of each probe.
Parameter Description
ipaddr|hostname The ipaddr value should be a valid IP address. The hostname value should be
a valid hostname.
initTtl Use initTtl to specify the initial time-to-live (TTL), the maximum number of router
hops between the local and remote system. Range is 0 to 255.
maxTtl Use maxTtle to specify the maximum TTL. Range is 1 to 255.
maxFail Use maxFail to terminate the traceroute after failing to receive a response for this
number of consecutive probes. Range is 0 to 255.
interval Use interval to specify the time between probes, in seconds. Range is 1 to 60
seconds.
count Use the optional count parameter to specify the number of probes to send for each
TTL value. Range is 1 to 10 probes.
port Use the optional port parameter to specify destination UDP port of the probe. This
should be an unused port on the remote destination system. Range is 1 to 65535.
size Use the optional size parameter to specify the size, in bytes, of the payload of the
Echo Requests sent. Range is 0 to 65507 bytes.
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-25