NETGEAR GSM7228PS Cli Manual page 721

Table 11-41: VRRP Log Messages
Component Message
VRRP Changing priority to 255 for virtual router
with VRID 1 on interface 1/0/1
VRRP Changing priority to 100 for virtual router
with VRID 1 on interface 1/0/1
VRRP vrrpPacketValidate: Invalid TTL
Table 11-42: ARP Log Message
Component Message
ARP ARP received mapping for IP address xxx
to MAC address yyy. This IP address may
be configured on two stations.
Table 11-43: RIP Log Message
Component Message
RIP RIP : discard response from xxx via
unexpected interface
Table 11-44: DHCP6 Log Message
Component Message
DHCP6 relay_to_server: Cannot relay to relay server
intf xxx: not IPv6 enabled
Log Messages
Managed Switch CLI Manual, Release 8.0.3
Cause
When the router is configured with the
address being used as the virtual router ID,
the router's priority is automatically set to the
maximum value to ensure that the address
owner becomes the VRRP master.
When the router is no longer the address
owner, Switch CLI reverts the router's
priority to the default.
VRRP ignored an incoming message whose
time to live (TTL) in the IP header was not
255.
Cause
When we receive an ARP response with
different MAC address from another station
with the same IP address as ours. This
might be a case of misconfiguration.
Cause
When RIP response is received with a
source address not matching the incoming
interface's subnet.
Cause
Relay is enabled but neither the outgoing
interface nor the server IP address is
specified.
v1.0, July 2010
11-20