Show Ipv6 Vlan; Show Ipv6 Traffic - NETGEAR GSM7228PS Cli Manual

show ipv6 vlan

This command displays IPv6 VLAN routing interface addresses.
Format
show ipv6 vlan
Modes • Privileged EXEC
• User EXEC
Term Definition
MAC Address Shows the MAC address.
used by
Routing VLANs
The rest of the output for this command is displayed in a table with the following column
headings:
Column
Definition
Headings
VLAN ID The VLAN ID of a configured VLAN.
Logical The interface in unit/slot/port format that is associated with the VLAN ID.
Interface
IPv6 Address/ The IPv6 prefix and prefix length associated with the VLAN ID.
Prefix Length

show ipv6 traffic

Use this command to show traffic and statistics for IPv6 and ICMPv6. Specify a logical, loopback,
or tunnel interface to view information about traffic on a specific interface. If you do not specify
an interface, the command displays information about traffic on all interfaces.
Format
show ipv6 traffic [{<unit/slot/port> | loopback <loopback-id> | tunnel
<tunnel-id>}]
Mode Privileged EXEC
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
7-28