Boot Autoinstall Auto-Save; Boot Autoinstall Start; Boot Autoinstall Stop - NETGEAR GSM7228PS Cli Manual

boot autoinstall auto-save

This command is used to enable automatically saving the downloaded configuration on the switch.
.
Default Disabled
Format
boot autoinstall auto-save
Mode Privileged EXEC
no boot autoinstall auto-save
This command is used to disable automatically saving the downloaded configuration on the
switch..
Format
no boot autoinstall auto-save
Mode Privileged EXEC

boot autoinstall start

The command is used to start Auto Install on the switch. Auto Install tries to download a config
file from a TFTP server..
Format
boot autoinstall start
Mode Privileged EXEC

boot autoinstall stop

The command is used to A user may terminate the Auto Install process at any time prior to the
downloading of the config file. This is most optimally done when the switch is disconnected from
the network, or if the requisite configuration files have not been configured on TFTP servers.
Termination of the Auto Install process ends further periodic requests for a host-specific file.
Format
boot autoinstall stop
Mode Privileged EXEC
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-3