Debug Ping Packet - NETGEAR GSM7228PS Cli Manual

debug ping packet

This command enables tracing of ICMP echo requests and responses. The command traces pings
on the network port/ serviceport for switching packages. For routing packages, pings are traced on
the routing ports as well.
Default disabled
Format
debug ping packet
Mode Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[181040176]: sim_debug.c(128) 20 % Pkt TX
- Intf: 1/0/1(1),
SRC_IP:10.50.50.2, DEST_IP:10.50.50.1, Type:ECHO_REQUEST
<15> JAN 01 00:21:22 192.168.17.29-1 SIM[182813968]: sim_debug.c(82) 21 % Pkt RX
- Intf: 1/0/1(1), S
RC_IP:10.50.50.1, DEST_IP:10.50.50.2, Type:ECHO_REPLY
The following parameters are displayed in the trace message:
Parameter Definition
TX/RX TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
Intf The interface that the packet came in or went out on. Format used is unit/slot/port (internal
interface number). Unit is always shown as 1 for interfaces on a non-stacking device.
SRC_IP The source IP address in the IP header in the packet.
DEST_IP The destination IP address in the IP header in the packet.
Type Type determines whether or not the ICMP message is a REQUEST or a RESPONSE.
no debug ping packet
This command disables tracing of ICMP echo requests and responses.
Format
no debug ping packet
Mode Privileged EXEC
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-78