NETGEAR GSM7228PS Cli Manual page 581

host
This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32.
Default none
Format
host <address> [{<mask> | <prefix-length>}]
Mode DHCP Pool Config
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode DHCP Pool Config
lease
This command configures the duration of the lease for an IP address that is assigned from a DHCP
server to a DHCP client. The overall lease time should be between 1-86400 minutes. If you specify
infinite, the lease is set for 60 days. You can also specify a lease duration. Days is an integer
from 0 to 59. Hours is an integer from 0 to 23. Minutes is an integer from 0 to 59.
Default 1 (day)
Format
lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode DHCP Pool Config
no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode DHCP Pool Config
Utility Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
9-44