Spanning-Tree Edgeport All; Spanning-Tree Bpduforwarding - NETGEAR GSM7228PS Cli Manual

no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format
no spanning-tree port mode all
Mode Global Config

spanning-tree edgeport all

This command specifies that every port is an Edge Port within the common and internal spanning
tree. This allows all ports to transition to Forwarding State without delay.
Format
spanning-tree edgeport all
Mode Global Config
no spanning-tree edgeport all
This command disables Edge Port mode for all ports within the common and internal spanning
tree.
Format
no spanning-tree edgeport all
Mode Global Config

spanning-tree bpduforwarding

Normally a switch will not forward Spanning Tree Protocol (STP) BPDU packets if STP is
disabled. However, if in some network setup, the user wishes to forward BDPU packets received
from other network devices, this command can be used to enable the forwarding.
Default 2
Format
spanning-tree bpduforwarding
Mode Global Config
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-22