NETGEAR GSM7228PS Cli Manual page 233

no dos-control smacdmac
This command disables Source MAC address = Destination MAC address (SMAC=DMAC)
Denial of Service protection. This command is only available on FSM72xxRS switches.
Format
no dos-control smacdmac
Mode Global Config
dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port =Destination
TCP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with Source TCP Port =Destination TCP Port, the
packets will be dropped if the mode is enabled. This command is only available on FSM72xxRS
switches.
Default disabled
Format
dos-control tcpport
Mode Global Config
no dos-control tcpport
This command disables TCP L4 source = destination port number (Source TCP Port =Destination
TCP Port) Denial of Service protection. This command is only available on FSM72xxRS switches.
Format
no dos-control smacdmac
Mode Global Config
dos-control udpport
This command enables UDP L4 source = destination port number (Source UDP Port =Destination
UDP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with Source UDP Port =Destination UDP Port, the
packets will be dropped if the mode is enabled. This command is only available on FSM72xxRS
switches.
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-197