NETGEAR GSM7228PS Cli Manual page 516

Term Definition
Committed Burst The committed burst size, used in simple policing.
Size (KB)
Committed Rate The committed rate, used in simple policing,
(Kbps)
Conform Action The current setting for the action taken on a packet considered to conform to the policing
parameters. This is not displayed if policing is not in use for the class under this policy.
Conform COS The CoS mark value if the conform action is set-cos-transmit.
Conform DSCP The DSCP mark value if the conform action is set-dscp-transmit.
Value
Conform IP The IP Precedence mark value if the conform action is set-prec-transmit.
Precedence
Value
Drop Drop a packet upon arrival. This is useful for emulating access control list operation using
DiffServ, especially when DiffServ and ACL cannot co-exist on the same interface.
Mark CoS The class of service value that is set in the 802.1p header of inbound packets. This is not
displayed if the mark cos was not specified.
Mark IP DSCP The mark/re-mark value used as the DSCP for traffic matching this class. This is not
displayed if mark ip description is not specified.
Mark IP The mark/re-mark value used as the IP Precedence for traffic matching this class. This is
Precedence
not displayed if mark ip precedence is not specified.
Mirror Copies a classified traffic stream to a specified egress port (physical port or LAG). This
can occur in addition to any marking or policing action. It may also be specified along with
a QoS queue assignment. This field does not display on GSM7328S and GSM7352S
platforms.
Non-Conform The current setting for the action taken on a packet considered to not conform to the
Action
policing parameters. This is not displayed if policing not in use for the class under this
policy.
Non-Conform The CoS mark value if the non-conform action is set-cos-transmit.
COS
Non-Conform The DSCP mark value if the non-conform action is set-dscp-transmit.
DSCP Value
Non-Conform IP The IP Precedence mark value if the non-conform action is set-prec-transmit.
Precedence
Value
Policing Style The style of policing, if any, used (simple).
Redirect Forces a classified traffic stream to a specified egress port (physical port or LAG). This
can occur in addition to any marking or policing action. It may also be specified along with
a QoS queue assignment. This field does not display on GSM7328v1 and GSM7352Sv2
platforms.
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
8-29