NETGEAR GSM7228PS Cli Manual page 297

no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor.
Format
no area <areaid> virtual-link <neighbor> retransmit-interval
Mode Router OSPF Config
area virtual-link transmit-delay (OSPF)
This command configures the transmit delay for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The range for seconds is 0 to 3600 (1 hour).
Default 1
Format
area <areaid> virtual-link <neighbor> transmit-delay <seconds>
Mode Router OSPF Config
no area virtual-link transmit-delay
This command resets the default transmit delay for the OSPF virtual interface to the default value.
Format
no area <areaid> virtual-link <neighbor> transmit-delay
Mode Router OSPF Config
auto-cost (OSPF)
By default, OSPF computes the link cost of each interface from the interface bandwidth. Faster
links have lower metrics, making them more attractive in route selection. The configuration
parameters in the auto-cost reference bandwidth and bandwidth commands give
you control over the default link cost. You can configure for OSPF an interface bandwidth that is
independent of the actual link speed. A second configuration parameter allows you to control the
ratio of interface bandwidth to link cost. The link cost is computed as the ratio of a reference
bandwidth to the interface bandwidth (ref_bw / interface bandwidth), where interface bandwidth is
defined by the bandwidth command. Because the default reference bandwidth is 100 Mbps,
OSPF uses the same default link cost for all interfaces whose bandwidth is 100 Mbps or greater.
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-49