Ipv6 Configuration Example - 3Com 4210 PWR Configuration Manual

540 C 46: IP 6 M
HAPTER V
IPv6 Configuration
Example
IPv6 Unicast Address
Configuration
C
ANGEMENT ONFIGURATION
Network requirements
Two switches are directly connected through two Ethernet ports. The Ethernet
ports belong to VLAN 2. IPv6 addresses are configured for the interface
Vlan-interface2 on each switch to verify the connectivity between the two
switches. The global unicast address of Switch A is 3001::1/64, and the global
unicast address of Switch B is 3001::2/64.
Network diagram
Figure 193 Network diagram for IPv6 address configuration
Vlan-interface 2
Switch A
Configuration procedure
1 Configure Switch A.
# Configure an automatically generated link-local address for the interface
Vlan-interface2.
<SwitchA> system-view
[SwitchA] interface Vlan-interface 2
[SwitchA-Vlan-interface2] ipv6 address auto link-local
# Configure a global unicast address for the interface Vlan-interface2.
[SwitchA-Vlan-interface2] ipv6 address 3001::1/64
2 Configure Switch B.
# Configure an automatically generated link-local address for the interface
Vlan-interface2.
<SwitchA> system-view
[SwitchB] interface Vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address auto link-local
# Configure a global unicast address for the interface Vlan-interface2.
[SwitchB-Vlan-interface2] ipv6 address 3001::2/64
Verification
# Display the brief IPv6 information of an interface on Switch A.
[SwitchA-Vlan-interface2] display ipv6 interface vlan-interface 2
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::20F:E2FF:FE47:4CA3
Global unicast address(es):
3001::1, subnet is 3001::/64 [DUPLICATE]
Vlan-interface 2
Switch B